Gold 1, Silver CMC Crypto 1, FTSE 7, Nikkei 28, Read full article. More content below. In this article:. About Granite. Story continues. Recommended Stories. Motley Fool. Yahoo Finance Video. Yahoo Finance. Investor's Business Daily. If you have any questions about insurance, please contact the Risk Management Division of the Department of Administration.
See Appendix C for insurance information. Whenever a tie involves a Minnesota vendor and a vendor whose place of business is outside the State of Minnesota, the award shall be made to the Minnesota vendor.
Except as provided in Section 2. Tied responses may also be subject to investigation or inquiry by the Attorney General's office to ensure that no collusion has taken place between or among vendors.
The State may reject any or all responses or portions thereof. Responses shall be rejected for good and sufficient cause, including, but not limited to, abandonment of the project by the State or insufficient State funds.
Pursuant to rule, rejected vendors must be notified of the rejection and the reason why the response was rejected. Responses must be reviewed to assure that they are signed. Responses filled out in pencil are no longer rejected. If an agency would like to conduct electronic bidding, the agency must submit a plan describing its process for approval by the OSP Acquisitions Manager. A response containing an alteration or erasure of any price contained in the response that is used in determining the successful response shall be rejected, unless the alteration or erasure is crossed out and the correction printed adjacent to the correction and initialed by the person signing the response.
This information must be stated in the solicitation document. For example, do not state "one saw," but indicate the saw's specification requirements. See How to Write Specifications, Sections 2.
Such practices will result in cancellation of the certified agency purchaser's authority for local purchase. Make certain the vendor receives the original copy of the signed order. This is the contract between your agency and that vendor, which obligates both parties to the terms and conditions of the contract. Proof of insurance from the awarded vendor is required for all service and construction work unless written approval is granted by OSP in consultation with the Risk Management Division.
The vendor must provide an insurance certificate naming the State of Minnesota as additional insured. If you have any special insurance needs or questions, call Risk Management at Agency heads are responsible for the State personal property acquired by their agency based on Minn.
Each agency must establish and publish departmental policies on how to account for property acquired by the agency. Consult the Department of Administration's Informational Bulletin State agency purchasers may issue DPOs for employee moves, per the terms and conditions of each employee's bargaining unit contract.
Employee moves no longer need to go through OSP. The State is capable of securing firm responses from vendors for employee moves pursuant to Minn. These entities are not, however, exempt from vendors' tariffs as filed with the Interstate Commerce Commission.
As defined by Minn. The original length of any contract cannot exceed two years, unless special approval has been received in writing from the appropriate AMS or the Acquisition Manager. All ALP certified purchasers are required to use State-approved contracting forms. Exceptions e. No contract for the purchase of goods, services, or utilities is valid without the signatures of the vendor, the designated agency representative, and OSP. Vendor Information. Cooperative Purchasing. ALP Manual.
Section 1: Authority for Local Purchase. Section 2: General Purchasing Procedures. Section 3: Exceptions to the Solicitation Process. The ALP dollar limits are not for individual items on a purchase order. Agency staff who split awards to stay under their purchasing limit are in violation of their purchasing authority. If the required goods or services are available on contract, an agency purchaser must proceed as follows: 2. Any exceptions must be approved by the OSP Acquisition Management Specialist if not listed as an acceptable exception on the contract release document.
Exceptions to using a State contract may be granted under certain circumstances. These attachments must be clearly marked with the entire requisition number to ensure that they reach the proper AMS and are correlated to the correct requisition.
This solicitation must be with a targeted or economically disadvantaged vendor if one is available within the area where the goods or services are normally purchased. It is not possible to control multiple lights at the same time without a home network router but you can still use the wifi-socket access point to program multiple lights in locations without a home network router.
You will just have to connect to each light separately to control and program it. For the example we will use Orphek Left for the first unit, Orphek Center for the second and Orphek Right for the third unit. You can choose the names you wish for each light. Because this method does not allow you to control more than one light at a time it is not recommended for locations where wireless communication cannot be used.
Begin by unplugging all units waiting 30 seconds and then plugging in one unit. Only one unit can be plugged in and programmed initially. Once all units have been programmed they can all be plugged in and operated at the same time. This is accomplished by finding the light access point on your wifi connection. This can be google chrome or any other web browser that is installed on your Android device.
For example: set this IP for First unit Access your wifi connections again via the android settings and you will be able to see the lights, each listed as a separate wireless access point.
Choose the light you wish to program first, connect to it and proceed to section 3. Once you have programmed the first light you will need to connect to the next light and program it and then the same for the third.
Because this method does not allow you to control more than one light at a time it is not recommended for locations where wireless can be used. We strongly urge you to use the Static IP methods in sections 2. Connect to the light of your choice from all available lights and then proceed to section 3 for programming. Now you need to open the Orphek app. Return to your home screen and locate the Orphek app and click on it to open.
Connecting your Atlantik series light to your home router and allowing the network to control the IP address is the easiest way to connect the lights. This method often allows you to go back in and set a static IP after the fact which will add more stability to your system. Allowing the router to assign IP addresses often causes conflicts down the road when using the Orphek app at a later date.
While this is not a big issue, its best in the long run to use the static IP address setup outlined in sections 2. This can be Google Chrome or any other web browser that is installed on your Android device. Once you have entered all of the correct info and ensured that it is all correct, you will need to restart the system.
Once the system restarts you will lose connection with the wifi socket and you should get some sort of error screen on your browser notifying you that connection has been lost or unable to connect to The NYSE would have the discretion to impose more stringent requirements than those set forth above.
Factors that would be considered include:. A reverse merger company would not have to comply with the requirements of Section Furthermore, the offering must be made subsequent to or concurrently with the reverse merger. A reverse merger company will no longer be subject to the minimum price trading requirement of Section Such a company would have to meet the stock price requirement of Section In addition to meeting the criteria set forth above, a company that was formed by a reverse merger would be required to comply with one of the initial listing standards for operating companies set forth in Section For further information, please contact Timothy M.
0コメント